Key points for dehydrating liquefied gas cylinders
Thread Content
Points to note during work: do not leave the spot
These posts are a bit vague; it’s not clear what you’re trying to say. Please make sure to express your intentions clearly
Looking at the posts made by this SeaUser, they’re basically all like this~~~
They have been asked to study the rules carefully, and they have been reminded not to post irrelevant content. They registered not long ago; we’ll have to wait and see their actual behavior:handshake
The process is automatically shut off during dehydration.
Points to note for dehydration: 1. Two people should work simultaneously； 2. Watch the wind direction and stand on the upwind side ； 3. First open the valve on the outside, then open the valve at the root, doing so slowly ； 4. If the water flow is poor or freezing occurs, close the valve and use steam to heat it up or clear the blockage ； 5. Once dehydration is complete, close the root valve, dehydration valve, and vent valve ； Do not leave until the inspection is complete ；