How to operate when the stabilizer tower is at full capacity for a long time
Thread Content
This post was last edited by Refiner on 2017-7-21 08:50. How to operate when the tower is full for a long time
Identify the reasons for the full tower condition and take appropriate actions to address them: 1. An excessive amount of deethanized gasoline enters the stabilizer tower, while less stabilized gasoline is sent out; 2. Instrumentation failure; 3. The temperature at the bottom of the stabilizer tower is too low, preventing light components from evaporating
Are you referring to a full tower, or is the liquid level at the bottom of the tower too high? In the event of flooding, the issue of instruments should be considered first, followed by the load on the tower. As an emergency measure, it is necessary to reduce the feed rate, the reflux rate, and the load on the reboiler at the bottom of the tower… If the liquid level at the bottom of the tower is high, then, while maintaining product quality, the amount of material sent to external discharge should be increased (to stabilize the gasoline composition); otherwise, the reboiler load needs to be increased, and the pressure and reflux rate at the top of the tower should be raised slightly to improve the distillation efficiency. As a temporary solution in emergencies, the feed rate can be reduced
Why wait until his tower is full? As long as the requirements specified in the process card are not met or a level alarm is triggered, the cause should be identified and addressed promptly. In addition to the reasons mentioned above, it is also possible that the steam stabilization and delivery process is not functioning properly.
This is absolutely not allowed! ! ! ! ! First, analyze the cause: Is the instrument functioning properly? Such problems do not occur under normal operating conditions, as there is a balance and the inflow and outflow are equal. Check the instrument first ； Second, check the process operation parameters to see if the temperature, pressure, and flow rate are within the specified ranges ； Does the amount of the third absorbent change significantly? If the liquid level is indeed at its maximum, it’s necessary to reduce the temperature promptly and lower the feed rate; first maintain a normal liquid level before resuming normal operations. . .
Reduce the reflux flow, increase the outward flow rate, and slightly raise the temperature of the reboiler at the bottom of the tower. If nothing else works, just vent the rough gas
For a long time? First, you should reduce the amount – that’s the principle