How to install the reinforcement ring at the diameter-changing section of the tower?
Thread Content
This post was last edited by YeTangZhangShang on 2019-11-14 at 12:35. 1. When the larger end of the reducer section serves as the support line, does it mean that no stiffening rings are required for the larger-end cylinder? 2. Also, after entering the reinforcement rings, why does the calculation sheet show reinforcement rings at both the larger and smaller ends? Do I have to add it if I want to?
This drawing is wrong; the ‘d’ that causes you to lose is that D in the picture
Oh, I see. Thank you! So, where exactly in the throat section should this reinforcement ring be placed, on the upper or lower side?
This transition section of yours is nothing but an externally pressurized conical shell
This post was last edited by wanlirn on 2019-7-23 09:35 on the cylinder
On the cylinder section of the diameter-changing section? Are there any requirements regarding the location?
Is the reinforcement ring for the diameter-changing section placed on that section? Are there any requirements regarding the specific location (distance from the upper and lower welds)?
Then, for my “big-end as support line,” do I still need to add a “reinforcement ring” on the big-end sleeve?
Then, for my “big-end as support line,” do I still need to add a “reinforcement ring” on the big-end sleeve?