Skirt shell stress verification
2022-03-09View Original
Thread Content
When checking the stresses in the skirt, how are the angles indicated in the diagram determined? ?Reply #22022-03-11
This value can be seen by simply measuring it
Related Threads in This Forum
← Previous
- The methane content in the off-gases from the cryogenic dist
- Oil circulation in the middle section of the distillation to
- Seeking help with a pressure tower – pressure control scheme
- Can the water quality requirements for feeding water at the
- Q&A on Basic Tower Knowledge 28---When designing the structu
- Water is dripping at the outlet of the desulfurization tower
- Relationship between air compressor inlet volume and distill
- Alcohol distillation tower - HCBBS Forum
- How is the diameter of a liquefied gas desulfurization tower
- I would like to ask everyone: after the entire Aspen process
Next →
- Strength verification of packing supports (support rings) in
- Estimation of the weight of the medium inside the tower duri
- How is the internal diameter of a small packed distillation
- How to resolve these warnings when using PROⅡ to simulate th
- How are large towers made round, and what are the same proce
- How can the granulation process produce particles similar to
- Regarding the temperature control of the tower top condenser
- Liquid in the dry gas desulfurization tower - HCBBS Forum
- For the side-line stripping tower, is the amount of strippin
- Effect of the inlet structure of the scrubber tower on dust
Translated at 2026-07-26 09:08:36
Original: https://bbs.hcbbs.com/thread-3309634-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.