Please tell me about the gas and liquid directions of this vacuum pump.
Thread Content
This is a new water ring vacuum pump that our company has recently purchased. I don’t know where the gas enters and where it exits, and where the liquid enters and exits.
There is a buffer tank at the outlet of the vacuum pump, which can separate steam and water.
The can is a soda-water separation tank. The suction port is the flange port facing upward, and the horizontal one is the exhaust port, which is connected to the soda-water separation tank.
After reading the answers above, there is basically no useful information. This kind of entrance and exit can be adjusted in the direction, such as entering from the upper left and exiting from the lower right. ； Enter the upper right, exit the lower left ； But remember to adjust the direction of the rotor.
Looking at the picture, the poster should be the water ring vacuum pump used in the newly built PSA pressure swing adsorption device. In the first picture, the top right side is the gas suction inlet, and the left side is the outlet. The exhaust gas carries part of the water vapor to the separation tank at the outlet. The gas goes from the top of the tank to the back-channel system, and the water remains in the tank. There is a connecting pipe between the tank and the pump body, so that the two always maintain a certain liquid level. If the liquid level is low, the water is automatically replenished through the water replenishment solenoid valve, which is probably like this.