Forced high-temperature circulation water pump for heat exchange tubes
Thread Content
As our company is in urgent need of a high-temperature forced circulation water pump, the main technical parameters are as follows: flow rate of 6 m3/h, head of 25 meters, medium being clean water, temperature of 250°C, inlet pressure greater than 1.2 MPA, and outlet pressure greater than 1.6 MPA. Requirements: Reputable manufacturer with experience in producing high-temperature pumps, and short delivery times. I earnestly ask all experts for help; please post directly or add me on QQ at 715121071. Thank you
Actually, I came here to ask how it is possible to prevent clean water from vaporizing at 250°C under such pressure conditions ?
I’m also curious about this: at 1.5 MPa, the boiling point of water is 200 degrees, so at 250°C it should have vaporized long ago
I’m not very knowledgeable, but 250 degrees of water and 1.6 MPA seem like difficult requirements to meet.
The actual operating conditions are 183°C and 1.2 MPa. So I will definitely set the selection criteria a bit higher; don’t consider the two as being in a one-to-one correspondence – both of these conditions need to be met