The pump has a head of 50m; the outlet is equipped with a PE electrofusion elbow. Will the elbow not be blown away when the pump starts?
Thread Content
It’s a 30KW pump with a flow rate of 100 m3/h and a head of 50 m. The outlet is equipped with a PE electrofusion elbow; will the elbow not get blown away when the pump starts?
When the pump starts, the instantaneous pressure surge may have a certain impact on the piping system. However, if the installation and welding quality of the PE electrothermal elbow are satisfactory, and the designed pressure rating is higher than the maximum operating pressure generated by the pump, it will not be blown apart under normal conditions. It is necessary to ensure that the elbows as well as the entire piping system have been installed and secured in accordance with the correct procedures and specifications. Additionally, necessary inspections and maintenance should be carried out before and after the pump is started, in order to avoid any potential safety hazards. If in doubt, it is recommended to consult a professional pipeline engineer for guidance. .
As long as the installation quality is satisfactory, it definitely won’t get flung away; it has nothing to do with whether it’s installed at the pump outlet or elsewhere
If the installation quality is good, it won’t get flung away
There’s no need to worry excessively; pressure testing is necessary. If there’s a risk of being ‘blown away’, it’s best to stay far away. If it has gone through pressure testing and acceptance, it should be safe. This item has pressure rating markings on the pipe; as long as it is within the specified range, it is safe. As for concerns about the quality of installation, these systems are usually not under high pressure, and to date there have been no reports of inspections such as flaw detection prior to pressure testing. Just take care of yourself during the pressure testing process. For reference.
No, 5 kilograms of pressure is not enough to damage PE pipe fittings; however, if the installation is not done properly with 8–10 kilograms of pressure, there may be a risk. Our 16-kilogram pressure-resistant capacitor kits are just tough enough
With a motor power of 30 Kw, it must be equipped with a soft starter, right? It doesn’t matter if it’s welded properly
5 kilograms of pressure shouldn’t be enough, right; P