The pressure applied by the vertical sludge pump does not reach the pressure specified on the nameplate
Thread Content
Our company has purchased a vertical sludge pump with a flow rate of 50 cubic meters per hour and a head of 32 meters; however, the pressure it can achieve during operation is only around 1.6 kilograms per square centimeter. Could any fellow sea traveler help share this?
This situation may be caused by the following reasons: 1. There may be blockages in the inlet and outlet pipes of the pump, or the pipe diameter may not be chosen appropriately, resulting in increased flow resistance. 2. Check whether the pump shaft is installed correctly and whether the bearings are worn. 3. Check whether the motor is suitable and can provide sufficient power for the pump. 4. There may be worn or damaged components inside the pump, and it is necessary to inspect its internal structure. 5. Perform system venting to ensure there is no air interference within the system. It is recommended to start checking and debugging from these aspects first. If the problem persists, please contact the supplier or a professional technician for a detailed inspection and repair. .