【Haichuan Pipeline Installation】Is it okay to just make holes?
Thread Content
Is it okay to just make the holes?
It can’t be the gauge connection at the pump outlet, right? If a reinforced fitting was used during installation and welding (it doesn’t seem to be the case), then it’s still barely acceptable. The workmanship is simply outstanding————
Does this need to be welded by insertion? This hole is probably damaged beyond repair now, right? Is it possible to weld such holes???
Many companies require such openings to be made mechanically
Gas cutting for hole creation: arbitrary and non-standard
It is best to drill the hole mechanically or using an internal grinding tool; if cutting the hole with gas, the diameter of the hole should be smaller than the required size, after which the internal grinding tool should be used to clean the area properly
:Dizzy: The water pipes here are basically all set up like this! I know it’s not appropriate, but it’s to save money~
The grinder was used to grind and create the bevel
The grinder was used to grind and create the bevel