Flue gas pipeline
Thread Content
Is it necessary to install expansion joints in the horizontal pipe section from the flue gas collector duct to the triple swirl?
Anyway, we didn’t add it here. . . .
Calculate the expansion amount and then decide. If the horizontal section is short, it needs to be added.
Haven’t we added it here either? I’m not sure what the original poster is trying to ask But additions were made on both sides of the three-spin outlet leading to the smoke extractor, as well as on the double-acting slide valve ；
You can’t just add this thing whenever you want; it needs to be calculated. Don’t look at how others are; focus on whether it’s truly needed.
Our device doesn’t have it installed; it’s about 20 meters long roughly
It still needs to be calculated before addition; it is mainly used to accommodate the expansion during start-up and shutdown phases. If the impact is minimal, it may be possible to omit it.