How does Flanta ensure the gap and sealing performance of the flange seal surface?
Thread Content
Due to manufacturing errors in the equipment and mistakes in the construction of its foundation, the gap between the sealing surfaces of the flanges during the lifting of the flange tower equipment is not always within the range that can be adjusted by using gaskets. What measures can be taken to ensure the proper gap between the flange sealing surfaces and maintain good sealing performance?
Is Fantar not a new creation either? Is the question \"a question with no problem\"?
Gurus, do you have any suggestions? Any suggestions are welcome.
Control deformation to ensure manufacturing precision
The flange is generally small and can be lifted as a whole
It can be lifted as a whole, but the joints are prone to leakage. How to avoid it?
After the strength calculation is completed, the stiffness should be calculated as well; thin-walled towers may deform due to insufficient stiffness near the flanges when these flanges are tightened, preventing the gaskets from being compressed properly. I’ve encountered it.