Selection of precision filter elements
Thread Content
This post was last edited by guan*nchu on 2015-7-15 07:30. Hello everyone, I have just purchased a precision filter and don’t know much about it; I would appreciate your help in choosing the appropriate filter element as well as the number of such elements needed. Thank you! Medium: Some kind of gas ； Flow rate: 1600 kg/h ； Viscosity: 0.02cp ； Pressure: 3.3mpa ； Temperature: 45 degrees ； Density: 33kg/m3 ； Filtering precision: The filtration efficiency at 1.3 microns is 98% ； Filter element: Sintered 304 filter element; initial pressure difference: 0.007 MPa(g), maximum pressure difference: 0.013 MPa(g).
It would be best to provide information on the selection process and the calculation methods, please. Thank you!
I don’t understand this yet, but you can contact one of my friends who knows about it; his email address is wang.tm@ibs-sh.cn. You might want to try reaching out to him
This post was last edited by guan*nchu on 2015-7-15 20:27. Thank you! I’ll give it a try. What does your friend do?
1.3 microns; powder sintering is better.
So how should the number of filter elements be calculated? Thank you!