On June 12, 2016, there was a prize for those who participated in answering questions; those interested should join quickly!
Thread Content
To boost participation in the tower-related section and increase its popularity, we use simple methods to motivate everyone; by doing so, they can not only earn wealth but also learn the standards and reinforce their knowledge. Short answer: Under what circumstances should the general design drawing of a tower-type vessel be stamped with the design permit seal for special equipment?
The chapters on the design of pressure vessels and urban and rural planning, I guess
The general design drawing of pressure vessels falling within the scope of the \"Regulations on Safety Supervision of Fixed Pressure Vessels\" shall bear the design license seal for special equipment
General design drawing of pressure vessels within the scope of the \"Regulations on Safety Inspection of Fixed Pressure Vessels\"
Under what circumstances should the general design drawing of a tower-type container be stamped with the design license for special equipment? Paragraph b) of Article 4.2.2.2 of GB150.1 stipulates that the general design drawing of pressure vessels falling within the scope of the \"Safety Technical Inspection Regulations for Fixed Pressure Vessels\" must bear the seal for design approval of special equipment.
Pressure vessels within the scope of application of the Fixed Volume Regulation
They belong to pressure vessels (with requirements regarding volume and pressure), and must bear a seal indicating approval for design of special equipment
The general design drawing of tower-type vessels falling under the scope of the \"Safety Technical Inspection Regulations for Fixed Pressure Vessels\" (TSG R0004) must bear the seal for design approval of special equipment.