Overpressure of safety water seal
Thread Content
What are the common causes of overpressure in the safety water seal for gas-water separation, and how should it be addressed?
Overpressure in the safety water seal? It’s either poor drainage or an excessive amount of water being supplied.
Hello, both aspects are likely required. How did you choose the route for the expansion gas on your end?
Hello, it should be both of these aspects. Could you tell me about the operation of the expansion gas system in the gas-water separation unit over there?
I work at an oil refinery; I only have some basic knowledge of water seals.
I’m also very grateful for your reply. I would like to learn about the operation of the gas-water separation units in other coal-to-gas plants. It’s mainly related to the expansion gas system; waste gas treatment is truly a challenge
Do refineries have exhaust gas? What is generally used as a method for handling it?