Should the wire mesh demister be installed at the top or at the bottom?
Thread Content
Should the wire mesh demister be installed at the top or at the bottom?
Depending on the actual needs, this depends on the installation location.
Depending on the location, it’s of course easier to work on the upper garments than on the lower ones.
It depends on the specific installation location. Generally, if the manhole is above the installation location, it is more convenient to use an upper-mounted design; if the manhole is below the installation location, a lower-mounted structure is used, depending on which option makes installation and maintenance easier. Of course, there are exceptions as well; for instance, if there are manholes in both the upper and lower areas, but the space available for installing a manhole in the nearer location is limited, then one has to settle for a location that is further away. There are some differences between the upper and lower parts in terms of structural design, but the design and manufacturing costs are roughly the same.
The upper garment is more convenient; what matters most here is to consider where it will be installed and how it will be used – don’t find it troublesome
Why does it still show as unread even though it has been read?
There shouldn’t be any problem with this, right? The upper garment
There is no such thing as good or bad; it mainly depends on how well you can install a demister on your tower.