What should be the gap between the two halves of a plum blossom elastic block coupling?
Thread Content
Because the installer left too large an axial gap between the two halves of the coupling last time, around 1 CM, this caused the elastic blocks to be damaged, leading to wear and vibration in the bearings and gears.
It is generally 4-6 mm; pay attention to ensuring proper alignment
It’s not a fixed value; it mainly depends on the size of the device
I think it’s for alignment purposes; generally, no specific requirement is set for the gap!
It depends on the coupling diameter; generally, 3-6 mm is sufficient
Generally 3-5 mm, with the specific value determined based on the shaft’s positioning and expansion