Just a quick question: do the parameters need to be changed after moving an electromagnetic flowmeter?
Thread Content
After the electromagnetic flowmeter has been repositioned. With the change in the medium, the diameters of the other pipes remain the same, and the installation requirements are met. Is it usually sufficient to just fill the tank completely? No other parameters need to be changed.
If the pipe diameter is the same, the installation method remains unchanged; it is essential to ensure proper grounding, while no other parameters need to be altered. Then it is necessary to reset the zero point; the dielectric constant of the medium just needs to be within the measurable range.
Mm. If the requirements are met, it can be used weiterhin
As long as the dielectric conductivity is within the range specified by the flow meter, it’s fine
For conventional meters, if the range is inconsistent, it is necessary to adjust the range; if the meter display shows mass flow rate, the density also needs to be modified. There’s no need to change anything else.