One question per day (1115)
Thread Content
This post was last edited by Wang Tianze on 2015-11-16 at 19:42. 23. When choosing between air-open and air-close types for control valves, one should first consider (C). A. Product quality B. Product output C. Safety D. Efficiency 24. When using a multimeter to check whether a capacitor is good or not, if (C), then the capacitor is in good condition. A. Indicate full scale B. Indicate zero position C. Indicate from high to low until reaching zero D. Indicate from zero increasing until full scale is reached and then shut off
23. When selecting between air-open and air-close types for control valves, one should first consider (C). A. Product quality B. Product output C. Safety D. Efficiency 24. When using a multimeter to check whether a capacitor is good or not, if (C), then the capacitor is in good condition. A. Indicate full scale B. Indicate zero position C. Indicate from high to low until zero D. Indicate from zero increasing until full scale
23. When selecting between air-open and air-close types for control valves, safety (C.) should be considered first. 24. When using a multimeter to check whether a capacitor is good or not, if the reading (C.) decreases from high to low until it reaches zero, then the capacitor is good.
23. When selecting between air-open and air-close types for control valves, one should first consider (C). A. Product quality B. Product output C. Safety D. Efficiency 24. When using a multimeter to check whether a capacitor is good or not, if (C), then the capacitor is in good condition. A. Indicate full scale B. Indicate zero position C. Indicate from high to low until zero D. Indicate from zero increasing until full scale
23..C 24..C
23. When selecting between air-open and air-close types for control valves, one should first consider (C). A. Product quality B. Product output C. Safety D. Efficiency 24. When using a multimeter to check whether a capacitor is good or not, if (C), then the capacitor is in good condition. A. Indicate full scale B. Indicate zero position C. Indicate from high to low until zero D. Indicate from zero increasing until full scale
23. When selecting between air-open and air-close types for control valves, one should first consider (C). A. Product quality B. Product output C. Safety D. Efficiency 24. When using a multimeter to check whether a capacitor is good or not, if (C), then the capacitor is in good condition. A. Indicate full scale B. Indicate zero position C. Indicate from high to low until zero D. Indicate from zero increasing until full scale
23. When selecting between air-open and air-close types for control valves, one should first consider (C). A. Product quality B. Product output C. Safety D. Efficiency 24. When using a multimeter to check whether a capacitor is good or not, if (C), then the capacitor is in good condition. A. Indicate full scale B. Indicate zero position C. Indicate from high to low until zero D. Indicate from zero increasing until full scale
For question 24 in C Safety, I have doubts about the options. When using a multimeter to measure a capacitor, shouldn’t there be a value at first (not zero, right?), and then it should reach its maximum value?