Selection of mixing mode
Thread Content
There is a device that uses a liquid to absorb gases and carry out reactions, with a small amount of solid catalyst also present in the liquid. Long-term stirring is required. What type of mixer can be chosen for this reaction?
There is a type of stirring using a hollow shaft; I’ll check it for you tomorrow
I might not need that one. My material is enamel-coated, so it’s very difficult to make it hollow
This three-phase mixing design is quite mature; a gas dispersion impeller can be used at the bottom layer. As for the central air system, it depends on the requirements; it is recommended to consult a professional manufacturer for design – it’s quite simple.
We at Beihua specialize in mixing. Generally, the bottom blades are concave turbine blades, and axial flow blades are added at the top depending on the liquid level; gas usually enters through the distributor at the bottom. If the material you mentioned is enamel, then it will be problematic if the blades are also made of enamel, as it’s not possible to create complex blades in that case
You can mention the size of the kettle, the density of the liquid, the density of the particles, the dimensions, the volume of ventilation, as well as the mixing requirements
It is recommended to provide the conditions and parameters to enable accurate design!