For equipment lined with PTFE (tetrafluoroethylene), if part of the fluorine lining is damaged, how can it be repaired?
Thread Content
Hello, everyone! For equipment lined with PTFE (tetrafluoroethylene), if part of the fluorine lining is damaged, how can it be repaired? There’s just a hole of about 5mm – is it possible to repair it? Please give me some advice! Thank you so much!
It depends on what kind of equipment it is and whether it’s easy to repair. The PTFE lining itself can be repaired; you just need to turn to a manufacturer specializing in PTFE linings. But you haven’t specified what kind of equipment it is.
Can it be repaired on-site? upstairs
This post was last edited by Linyi Qianda Zhu Guangqian on 2015-12-8 at 23:29. The repair is quite simple; local damage can be fixed on the spot, and after the repair it will look just like before. However, it requires professional technicians to carry out the repair.
Who can provide the phone number of a technician skilled in PTFE patching? ? ? ? Urgent! Thank you!
This needs to be repaired by the manufacturer; the factory itself is unable to carry out the repair
You can add me as a friend; I’ll first understand the situation.
It can be repaired; it’s best to find out which manufacturer provided the equipment and contact them to handle it.
It seems that DuPont has developed a successful F4 welding process, with weld strength greater than that of the base material.
It is usually from the original manufacturer. If you are in a hurry, OP, you can contact me! QQ77390271
If it’s urgent, call me; I’m not too far away in Nanjing. 18951032019, Xia Xinhua