Honeywell
Thread Content
I’ve been working on debugging the process recently; sometimes it’s necessary to modify the configuration. However, an “error in point creation” occurs during the download process. It shows as blue when viewed online, but everything works fine once it’s reactivated! ! Another issue is that it’s not possible to delete the loop; forced deletion is required.
Why isn’t anyone here to provide guidance? Is Honey’s expert available?
It’s fine; you can just reactivate it and use it again. There is an error code that you can check.
It may be impossible to delete a loop because, when it was first created, other modules used that point; later, those modules were no longer needed and new modules were created. However, the original module was not deleted properly, which is why it cannot be removed successfully. It might also be a bug in the program. It will be fine after a forceful deletion!