The control valve for the discharge of the high-pressure washer will not close properly
Thread Content
Since we drove it in May 2015, the device has also remained stable. Given the pressure in the high-pressure system, the gas-phase control valve of the high-pressure washer remains fully open; at best, it can be closed to 96%. Please have the expert take a look to see what’s causing it~
How much ammonia is consumed? Is the valve opening for the vapor phase in the low-temperature chiller liquid level tank of the low-pressure system also large?
Ammonia consumption is around 0.565; the opening degree of the low-pressure gas valve is not high, usually around 10%
What is the liquid level in your high-pressure washer? What is the opening degree of the high-pressure injector? We were unable to close it down before; later, by increasing the opening of the injector and keeping the liquid level in the high-pressure washer above 50, we were able to close the gas phase valve.
We use a pool reactor here without injectors~
It would be best to send over the high-pressure map from your control center so that everyone can study it