How should the venting tank used at the outlet of a safety valve be designed, and which standards can be referred to? Could everyone help look into this?
Thread Content
How should the venting tank used at the outlet of a safety valve be designed, and which standards can be referred to? Could everyone help look into this?
Same question! I’ve run into the same problem as well: if a flare is installed, there’s hardly any exhaust gas emitted in normal operation, so using a flare is somewhat wasteful. Moreover, the facility doesn’t allow the installation of flares. But let’s not pretend otherwise – if the reactor experiences overpressure and the gas released ends up in the atmosphere, that’s absolutely not allowed. Consider getting a pressure-rated pressure relief tank. Struggling to find standards and norms.
What happened later? What should I do? :)
I would like to know that too; just tell me where to find similar materials so I can research it on my own.