Poor discharge in the negative pressure stripping tower
Thread Content
What are the reasons for poor discharge from the stripping tower, and how can it be resolved? Thank you! !
What do you mean by poor material feeding? Please describe it Negative pressure at the top of the tower, steam at the bottom of the tower, temperature difference across the trays, feed temperature, and bottom temperature of the tower?
Is the poster the slurry stripping tower? As mentioned on the sofa, please describe in detail the specific situation of poor material feeding! Also, check to see if it’s being supported! ? When material loading occurs, the temperature and pressure inside the tower also fluctuate intermittently. Is there any blockage in the stripping tower?
Excessive steam flow causes material to get stuck on the tray; reducing the steam volume appropriately can help clean the trays more effectively.
The poor discharge from the stripping tower is mainly related to steam pressure; it is essential to ensure that there is sufficient steam pressure. If there are difficulties in the early stage, the feed rate can be reduced ； Increase the flushing time for the tray water and reduce the interval time ； Do not set the temperature at the bottom of the tower too high to avoid material buildup.