Piston compressor stroke calculation
Thread Content
When designing a compressor with an air volume flow rate of 0.6 m3/min and an air pressure of 0.8 MPa, the empirical formula S=AP1/2 is used to calculate the stroke length; A ranges from 0.065 to 0.095, and P is expressed in tons. Once the stroke length is determined, it is used to calculate the rotational speed. 100T=1Mpa; if A=0.07 is used, then S=0.626m, which is clearly incorrect. I’m seeking help to figure out where the mistake lies – perhaps the calculation for the stroke isn’t correct. Thank you! :D
I’ll hold on by myself; please help, experts :(
Support the original poster, give it a boost; P
p is the piston force, not the outlet pressure
Thank you{:1_90:}