Seeking help with issues regarding container wall thickness design
Thread Content
According to the standard formula, the minimum applicable range for 16MnR steel is from 6 to 16. Since my pressure vessel is relatively small, the calculated thickness comes out to be a little over 3 mm. After adding a 3 mm corrosion allowance, the design thickness becomes a little over 6 mm, which seems to fall within the specified range. Is this calculation method correct?
You also need to consider the negative deviation in steel plate thickness
You need to use a cylinder thickness of 8mm； The thickness of the elliptical head is set at 8 mm, with a minimum thickness specified as 7 mm.