Oil pump design
Thread Content
The company is unable to ensure quality control over the operation of the helical gear pumps it designs and manufactures itself, as the helical gears are custom-made components. It is impossible to conduct inspections after processing, and quality cannot be controlled. Find a professional oil pump design firm/person to carry out the oil pump design. Rotational speed: 1000 r/min, flow rate: 380 L/min; lubricant grade: Great Wall LDAB100; operating temperature: 60–80°C.
This is a highly professional question; I hope someone knowledgeable can help.
A KCB gear pump is sufficient for transporting lubricating oil, and it’s inexpensive
The internal pump we built ourselves on the machine is a gear pump, and it generates quite a lot of noise
Are there standards for helical gears, and is special equipment required for inspection? The helical gears we are using have been tested at our sister company, and it was said that they are non-standard parts, so they cannot be inspected!
Generally, manufacturers that produce gears are able to conduct such inspections
Could you tell me what you’re asking for – a redesign?
Was the meshing clearance of the gears measured during installation? If the meshing clearance is not properly controlled during assembly, it will be difficult to ensure good performance of the machine. Also, it’s important to determine whether the bearings selected are capable of withstanding radial loads effectively
Rotational speed: 1000 r/min, flow rate: 380 L/min; lubricant grade: Great Wall LDAB100; operating temperature: 60–80°C. With the box dimensions and interface properly designed, the gears can be redesigned. If you’re interested, leave your contact information and I’ll give you the drawings
qq1606299646