Ignition of the fuel oil heater
Thread Content
How to light a heating furnace that uses fuel oil, and control of the atomized steam
Do you mean that fuel oil is burned as soon as the operation starts? This is a bit difficult.
First, adjust the fuel oil return pressure to ensure that the steam pressure is about 0.1 MPa higher than the fuel oil pressure. After that, use steam to blow and purge the furnace; set the flue dampers at 1/3 position, and do not open the air valves too wide at first. Place the torch above the burner nozzle in the furnace; introduce steam first, then feed the fuel oil
The first time we started operating the factory, we directly ignited it with fuel oil! The key is to be patient; the rest you know