I have a factory building that is 10X20 meters in size and 12 meters high. There are also equipment pieces that are 2X7 meters in size. How large should the door be to allow these items to enter the building? How to lift it
Thread Content
I have a factory building that is 10X20 meters in size and 12 meters high. There is vertical equipment with a diameter of 2 meters and a length of 7 meters. I want to install this equipment in the building. 1. If it’s placed on the first floor, what dimensions should be reserved for it (width and height)? ) the door? How to lift it into place (how to get it upright once it’s inside)? 2. If it is to be placed on the 2nd floor, what measures should be taken to ensure it can be lifted into place? ? I’m troubling the experts here! !
This post was last edited by jinqhuaxz on 2016-7-4 at 13:15. If this tower comes with SKIDs, it might be possible to install it inside the factory building; if that’s feasible, the requirements regarding doors will be much less stringent. Of course, the convenience of moving out also needs to be considered.
Sir, what does “tower with SKDI” mean?
It’s a skid-mounted unit that can be easily dragged into the factory building.
What’s on the 1st floor? What are the things that prevent lifting and turning? What’s on the 2nd floor? What are the things that prevent lifting and turning? Should the equipment be lifted first, or should the factory building be built first?
Sir, the first floor is empty; there are just a few columns there. The second floor is similar – it’s an existing factory building to which equipment will be added later. Sir, I just want to know what the differences are between lifting equipment onto the first floor and the second floor, and how each type of equipment should be lifted. Thank you!
I can’t be called a hero; I’m more of a fool. . . Put it on the 1st floor, entering horizontally through the door? Then, when turning over, it involves rotating 90 degrees around some point at the bottom as an axis. Is there a risk that this rotation point will be damaged or slip? Where does the force needed for turning over come from? Will the movement of this force (the crane + steel cable) cause it to collide with other objects? Place it on the 2nd floor: simply tear a hole in the roof and lift it into place. As long as it is within the lifting height limit allowed by the crane (in other words, after the equipment is lifted off the ground, it’s not necessary to break walls to get it inside the building), create an opening in the roof of a size smaller than that required for placement on the 1st floor, and then lift the equipment in through that opening. It’s safer.
Sir, if it’s placed on the 2nd floor where there are many towers, usually only one lifting hole is provided. How can the equipment be moved to its intended position once it’s dropped in? ?
Oh, different fields are like mountains apart; I have no idea how many towers you want to build, and I’ve never worked on building towers either. Make a mobile fixture that can be used to lift the equipment and then pull it away – is that possible? Also, after the crane hook lifts the tower, will the height above the ground be sufficient to allow it to enter the factory building?