Honeywell DCS controller battery failure alarm
Thread Content
I would like to ask everyone: if the battery voltage of the controller in Honeywell’s DCS system is low or the battery is damaged, how can an alarm be configured within the system? Thank you!
If it is C300 hardware, no configuration is required for this; as long as the voltage falls below the normal level, a system alarm will be triggered. For batteries, it is recommended to replace them every three years according to KB guidelines.
It’s a C300 system, but the battery here is damaged – liquid is leaking from it and the temperature is very high, yet there’s no system alarm!
Battery failures will trigger a system alarm
It should be included in the soft failures of the C300~~~