How do people set up the analysis sampling points for wet flue gas desulfurization systems?
Thread Content
I would like to know where the sampling and analysis points (for manual testing) are located in the wet flue gas desulfurization projects that everyone has experience with Especially for the sampling of flue gas and absorbent solution, how should the sampling point locations be determined, and how should the sampling be carried out?
Does smoke sampling refer to the installation locations of the inlet and outlet CEMS? It is generally installed on the straight sections of the flue, not at elbows or bends.
Flue gas sampling is generally installed in a straight section of the flue duct, usually in the same area as the flue gas instruments. There are many ways to sample the slurry.
You can check out the 75 76 standards!