Discussion on compressor air delivery volume issues
Thread Content
This post was last edited by penghh1985 on 2016-8-20 at 14:32. The air delivery volume of compressors is greatly affected by the temperature of the inlet raw gas; how do people ensure an adequate air delivery volume for compressors during summer, especially in southern regions?
Maintain a high inlet pressure and a low inlet temperature, and ensure that the compressor valves are in good condition as well.
For every 10°C decrease, power consumption per unit decreases by 6%
Reduce the temperature of the desulfurization cycle water. Heat exchange equipment is installed outside the pipeline, with spraying
Lowering the inlet temperature or increasing the inlet pressure can both increase the air injection volume. Additionally, a certain margin can be considered during the design phase, that is, the design should be based on the worst operating conditions in summer.
We used lithium bromide in the summer, and the results were good. In summer, it’s probably in the 20s degrees.
We installed lithium bromide at the inlet of our compressor and kept it running – the results are great! ! ! ! ! ! !