Lifting ear settings?
Thread Content
Making a funnel is equivalent to a small silo. When using it, lift it up and place it on the feed port. The funnel is open. How to set the lifting lugs? Side wall plate lifting lugs have no place to weld the connecting plate.
Weld a nose to the symmetrical sides of the funnel.
Should I add two rigid rings to this opening?
Lifting ear pads are not necessarily needed. Lifting lugs can be welded directly without supervision.
Make a funnel stand! Put lifting ears on the stand
It can be said that there are too many ways. First weld or rivet two reinforcing plates on the upper side wall, and then weld plate lugs or steel lifting lugs on the reinforcing plates.
It can be said that there are too many ways. First weld or rivet two reinforcing plates on the upper side wall, and then weld plate lugs or steel lifting lugs on the reinforcing plates.
It can be said that there are too many ways. First weld or rivet two reinforcing plates on the upper side wall, and then weld plate lugs or steel lifting lugs on the reinforcing plates.
It doesn’t have to be standard lifting lugs, right?