Corrosion problem of high-temperature pyrolysis nozzles for waste acid
Thread Content
Are there any good materials for the nozzles in acid waste cracking units that can prevent corrosion? Or is it possible to reduce the spray gun corrosion rate by other methods?
1. First, use a high-efficiency dryer to remove the moisture from the atomized water. 2. Try using 904 for the nozzle, but it’s a bit expensive.
Mark it down; waiting for experts’ advice:victory:
Well, I’ve learned it! Additionally, is it feasible to use compressed air outside the waste acid spray gun to disperse the acid mist and protect the gun itself?
The misting air volume must be properly controlled, as well as the air pressure and the pressure of the waste acid
Hey You, what are the pressures of your waste acid and the volume of the atomization air?
Learn a bit and take a look at some good suggestions!
There are already spray gun nozzles available in the domestic market, which can ensure that the gun will function properly for a year