After maintenance of the air compressor unit, should the pipes be restored directly or measured and adjusted according to the methods used during installation?
Thread Content
This post was last edited by A Le on 2016-12-13 at 16:40. As is well known, the installation of air compressors in MAN turbines imposes high requirements on the pipelines. After maintenance of the unit, should the pipelines be restored to their original state or measured and adjusted according to the methods used during installation? I hope those who have experience with the maintenance of such units will engage in lively discussions! :handshake
It depends on the degree of change; if there isn’t much change and it can be reinstalled easily, there’s no need to follow the installation procedures.
No modifications to the pipeline are required; it can be installed directly.
Avoid stress! Check carefully! Otherwise, it can easily lead to high vibration and scraping between the impeller and the ring!