Is calculation for extruded tees necessary?
Thread Content
How to calculate commonly used extruded tees? Relevant R parameters cannot be found in standards such as GB12459. Additionally, can a tee or elbow with the same wall thickness be directly selected based on the pipe wall thickness calculated from the design pressure and temperature?
What should be considered for an extruded tee? There are no standard parameters for R; everything is determined based on the manufacturer’s molds. If there are no special requirements, the thickness of the tee and elbow components should match that of the pipes, i.e., it should be consistent with the pipes
I’m not quite sure about this. There are also such types of pipe fittings; I always thought they were the same as three-way ball valves