Dichloroethane
Thread Content
Dear sea friends, may I ask what the flow rate of dichloroethane in the gas phase should be?
It’s hard to estimate. Without a temperature and pressure range, and only a flow rate being specified, how can one make a judgment?
It is the flow rate of dichloroethane at a gauge pressure of 0.1 MPa and a temperature of 30°C
Atmospheric pressure? Could it be that the vent pipe is open?~
No. The inside is at a slight positive pressure, around 30 KPa
Just use the recommended flow rate for general combustible gases – is there anything special about dichloroethane? This is what led the original poster to have doubts~
The recommended flow rate applies under normal temperature and pressure conditions; here I have a slight positive pressure, so I’m not sure how to determine this flow rate
That slight positive pressure can basically be ignored; just use the values at normal temperature and pressure