A place deep in the clouds, unseen
Thread Content
The condensate vent steam drifted onto the equipment and cable trays.
Why isn’t the vent pipe installed at a higher position?
The photo has to be viewed at an angle! :)
The steel structure of the device is severely corroded and needs anti-corrosion treatment. Also, you can perform condensation without increasing the vent volume; by cooling the vent steam, it will disappear
Thank you to the original poster; this photo has cured my cervical spondylosis that has plagued me for years. :lol
Photos taken with a phone – I didn’t pay attention to turning them around; just make do and take a look; P
This is not allowed; the steam needs to be directed away or to a higher place
The pressure is likely not high; venting at a higher point is necessary, and the pipe diameter is probably quite large
The vent steam should be directed to a height above the centralized discharge point.