Regarding elbows in imperial and metric units
Thread Content
Hello everyone. I have been learning about elbows recently. Does anyone have a table that shows the pressure specifications and wall thickness values for elbows in both imperial and metric units? Could you please provide one to me? Also, I reviewed the standard GB12459-2005 for steel butt-welded seamless pipe fittings; Appendix B states that the pressure specifications and wall thickness tables provided refer to the wall thickness of the pipelines connected to the fittings, rather than the wall thickness of the fittings themselves. Therefore, I would like to know: 1. Are the wall thicknesses of the pipelines connected to the fittings (such as elbows and tees) consistent? Also, how can one find out the wall thickness of a pipe fitting corresponding to pressure specifications? Thank you
There isn’t a specific correspondence, but there is such a table in the American standard; you can take a look at it. I’m not sure if the image will be visible?
There isn’t a specific correspondence, but there is such a table in the American standard; you can take a look at it. I’m not sure if the image will be visible? The standards are attached below! !