How to create a rainproof seal for pipe holes.
Thread Content
The pipe openings on the roof need to be made weatherproof – what are some good solutions according to this diagram? Seeking guidance
Make a square box that is 200 units high (the length and width should be such that they can accommodate the steps shown in the diagram). Measure the spacing between the 5 pipes at the top of the box and make holes there; then cut the box along these holes and assemble it on site. If welding is possible, make a few small welds on each side; if welding isn’t possible, use a detachable joint to facilitate future maintenance. I don’t even know if they can understand it.
I can’t quite understand it, but I’m very grateful anyway; a schematic diagram would probably make it easier to understand
Simply, first make an iron box to cover everything; the piping parts should be designed as separate units that can be joined together, and then sealed using rubber or silicone