[Process Engineering Division – Pipeline and Valve Technology Exchange Forum – Daily Question – Questions 03–17]
Thread Content
【Process Engineering Division – Pipeline and Valve Technology Exchange Forum – Daily Question – Questions 03–17】 The calculation of the allowable span for pipeline supports should be based on two criteria: strength and ( ). Stiffness. Note: Questions are valid only on the day they are posed (3 correct answers and 1 incorrect answer; responses that repeat content from previous posts will be removed). Responding in large numbers to existing posts is considered spamming, and such responses will not earn any points or may be awarded points at the discretion of the organizers.
This post was last edited by wyllnfs on 2019-3-17 09:17: GD--Stiffness