HCBBS Forum (日本語)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

HGCADに挿入されたブロックをどのように分解するか?

2015-12-14View Original

Thread Content

この投稿は最後にFORREST_GUMPによって2015-12-14 14:06に編集されました。HGCADに挿入されたブロックは、機器の接続口の向き調整など、修正が必要です。 まずブロックを「分解」する必要があり、「分解」コマンドを使っても、コピーしてから分解しても効果はありません。 解除するにはどうすればよいですか? @gn_1984 @ren6602121 @砂漠の中の魚
Reply #22015-12-14
refeditというコマンドを試してみてください。
Reply #32015-12-14
はは、「ブロック編集」、gn姉さん、ありがとう:D

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.