How to maintain ultra-pure water equipment for batteries

Thread Content

This post was last edited by hesonchang214 on 2019-10-25 at 22:16. 1. When operating a pure water production system, the operator should first turn it on and let it run for about 20 minutes to allow the components to settle in; this is done to reduce wear and tear between the various parts of the system. 　　2. The operating time of ultra-pure water equipment should ideally be between 2 and 5 hours; if the equipment runs for extended periods, its components will be overloaded, and over time the equipment may develop faults. Therefore, the staff should appropriately shut down the equipment to allow it to rest properly. 　　3. During the operation of the ultrapure water equipment, operators should pay attention to whether there are any abnormal noises resulting from friction between the various components of the equipment. If such noises are heard, the equipment should be stopped immediately, and lubricant should be applied to the connections between the components. 　　The above are the issues that staff need to be aware of when ultra-pure water equipment is in operation; I hope everyone can learn them.