Holbig variable adjustment interchange for reciprocating compressors
Thread Content
Stepless adjustment of Hörlig. Can the stepless adjustment of the intake valve in the same cylinder be interchanged? What is the purpose of the continuously adjustable probe located at the bottom of the reciprocating machine’s flywheel?
Measure the clearance of the continuously adjustable actuator rod; make sure to ask the manufacturer to modify the cylinder associated with the continuously adjustable regulator, otherwise when it is set to 50%, one of the cylinders may not function……
What is the principle behind this? Could you explain it in detail? Thank you
The mark at the bottom of the flywheel is made by the manufacturer based on the top dead center; it cannot be moved and is used as a reference point for the control system
Swapping is possible; it’s best to discuss this with the manufacturer. There are two key points to consider: one is the physical address and the activation lock, which generally don’t present any problems – just use the settings as they were before. The other point is the size of the nozzle inside the valve chamber; this part doesn’t break easily either, and it’s simple to disassemble and assemble. We consulted the manufacturer, and they also recommend using universal components for this purpose
The gap is used to control the stroke of the air valve; it’s mentioned in the instructions for stepless air volume adjustment – take a look at the accompanying documents
I understand the gap. I don’t understand why no work is done when it’s swapped
They can be interchanged; the probe is used to generate the signal for marking
Have you tried swapping them to see if it works normally?
We are a domestic manufacturer and have replaced parts for customers before