Rotary kiln
2017-05-28View Original
Thread Content
The refractory material around the first thermometer in the rotary kiln (at 1100 degrees) has fallen off; can it continue to operate without repair?Related Threads in This Forum
← Previous
- How to choose the foundation bolts for equipment - HCBBS For
- Is there a substantial difference between the 212 mechanical
- Does anyone understand this type of frequency converter? - H
- What is the impact on the dry gas seal after a centrifugal c
- What is the principle of this design of steam turbine rotor?
- A Brief Discussion on Automation in Food Factories and Compu
- Is it necessary to add a interlock shutdown logic for the hi
- 【Mechanical Equipment Technology Exchange Edition】Mechanical
- Heater - HCBBS Forum
- The filter cake filtered by the filter is very wet - HCBBS F
Next →
- Cannot the exhaust pipe at the outlet of the water ring vacu
- 【Ten Years of Rapid Development in Chemical Processing Equip
- What is a high-speed machine? ? ? ? ? Reciprocating compress
- Discussion on Compressor Vibration Analysis - HCBBS Forum
- Looking for recommendations for reduction motors - HCBBS For
- How to maintain the pressure of the lubricating oil in a cen
- The value of shielded pump G needs to be determined - HCBBS
- 3D animated demonstration of the working principle of screw
- How to create a compressor parameter table? - HCBBS Forum
- Under what process conditions are barrel bag pumps used? Wha
Translated at 2026-07-26 09:31:08
Original: https://bbs.hcbbs.com/thread-1783783-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.