Can a mechanical seal with a nominal diameter of 95 be used on a shaft with a diameter of 80?
Thread Content
Can a mechanical seal with a nominal diameter of 95 be used on a shaft with a diameter of 80?
Do you need to make new shaft sleeves to match the seal?
No, it is necessary to reconfigure the shaft sleeve.
No, it is necessary to reconfigure the shaft sleeve.
It should be fine; it’s just that the gap between the static ring and the shaft diameter is a bit large. If I tighten the bolts of the drive seat, it should be possible to install it
No, it will be too loose – the difference isn’t small at all. Add a shaft sleeve.
Sure, just use a bushing with a 95 rating.
You need to make a new shaft sleeve, and you must also ensure that there is enough space in the sealing chamber so that the mechanical seal gland can be installed there~~~~
No, the bushing is not suitable; it needs to be remade