drawing
2019-04-30View Original
Thread Content
Can anyone tell me if this is a drawing for pump selection? How should this drawing look?Related Threads in This Forum
← Previous
- Dry gas seal - HCBBS Forum
- The screw compressor works fine under no-load conditions aft
- N-axis adjustment mechanism - HCBBS Forum
- Answers to Guess the Device by Looking at the Picture 201802
- Internal safety valve of the compressor - HCBBS Forum
- York screw RXF-XJF compressors, major and minor repair proje
- If the reactor is equipped with an inverter for stirring, wh
- Professionalism - HCBBS Forum
- Seeking help regarding issues with the exhaust pumps of Hang
- Problems with the installation clearance of the speed probe
Next →
- Which member has information on horizontal (transverse) spir
- The torque sensor is installed correctly, so there’s no need
- How to formulate the formula for coupling alignment? - HCBBS
- Analysis of the reasons for high current during the operatio
- On the power analysis of centrifugal compressors - HCBBS For
- 【Ten Years of Rapid Development in Chemical Equipment】From 1
- Centrifuge performance curve - HCBBS Forum
- Renovation of Siemens cycle air compressors - HCBBS Forum
- The company’s equipment is equipped with an oil mist lubrica
- On axial flow compressor control - HCBBS Forum
Translated at 2026-07-26 10:07:52
Original: https://bbs.hcbbs.com/thread-2690090-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.