Help/What are some ways to address the problem of material accumulation at the outlet of the classifier wheel in a jet mill?
Thread Content
This post was last edited by Dragonflys on 2022-9-19 at 15:12. Due to changes in the product manufacturing process, material accumulation frequently occurs at the discharge outlet of the grading wheel (as shown in the diagram), resulting in fluctuations in particle size. I would like to ask if anyone has any good solutions?
①Reduce the feed rate. ② Use a screw feeder for uniform feeding. ③ When the frequency of the exhaust fan is increased (parameters need to be adjusted again, and the particle size will change). ④ It appears to be a horizontal classification wheel in the diagram; try using a vertical classification wheel instead