High-power LYWS-10 acoustic soot remover designed for coal-fired boilers

Thread Content

The high-power LYWS-10 acoustic soot remover is designed specifically for coal-fired boilers. To remove ash buildup on the heating surfaces of coal-fired boilers, various soot blowers are installed on these heating surfaces, including those in the boiler’s water wall, superheater, and economizer. Currently, generally, (1) short-stroke telescopic steam soot blowers are installed in the boiler furnace, and (2) long-stroke telescopic steam soot blowers are installed on the convective heating surfaces. However, due to the structural characteristics, working medium, and the effects of high-temperature environments, telescopic steam soot blowers often suffer from problems such as jamming in the nozzle, malfunctions, air leakage, failure to start up, damage to the heated surfaces, slag formation, and wear. This results in high maintenance requirements for such equipment, a low operational efficiency, and poses serious threats to the safe and economical operation of boilers as well as the safety of maintenance personnel. The high-power LYWS-10 acoustic soot cleaner designed specifically for coal-fired boilers is highly praised by users due to its low investment cost, rapid effectiveness, simple operation, and convenience of use. Technical features: 1. Replaces the original steam soot blower of the boiler. II. Extend the service life of the boiler heat exchanger. III. Improve the heat exchange efficiency of the boiler and remove the ash accumulation on the surface of its heat exchangers. IV. Reduce the maintenance workload associated with damage to the boiler’s heat exchange tubes caused by the original steam soot blowers in the boiler. V. It aids combustion, saves energy, reduces the flue gas temperature of the boiler, and improves the thermal efficiency of the boiler.