Width and depth of the partition groove for segmented sections
Thread Content
What determines the width and depth of the partition groove? Should it be greater than the thickness of the partition plus 2 mm? The depth should correspond to the thickness of the gasket. If the partition is 10 mm thick, then the width of the groove should be 12 mm, with the depth equal to the thickness of the gasket. It would be great if someone could send me simple detailed drawings, like those in the image below
It’s listed on page 151; you can take a look – the standards are clearly specified there.
According to GB/T151-2014 standard 6.5.3.2
If the thickness of the partition plate is 10, is the width of the groove in that partition plate then 12, which is 2 units more? And is its depth equal to the thickness of the gasket?
If the thickness of the partition plate is 10, is the width of the groove in that partition plate then 12, which is 2 units more? And is its depth equal to the thickness of the gasket?
For the width, yes; the depth of the partition groove should be greater than the thickness of the gasket
The gasket thickness is 4.5; 5 pieces will suffice